Furnish and install Entry Mats to the following specification, as supplied by Latham Australia Pty Ltd, ph +612 9879 7888, fax +612 9879 7666. Latham Roll-Up *(RDCC - recessed carpet) / (RSA-recessed abrasive) / (RDCV - recessed vinyl) / (SDCC - surface mounted carpet) / (SAA - surface mounted abrasive) / (SDCV - surface mounted vinyl) entry mat (A)…………… x (B)…………… in colour……………… (grey standard), aluminium to be *(standard clear anodised) / (bright bronze gold anodised) / ( bronze anodised).
*Delete that which does not apply.
Construction
A series of aluminium tread rails are spaced at 50mm centres and connected by a continuous neoprene hinge with uniform perforations to allow the effective control of water and small debris. Treads to run counter to walking direction, with tread surfaces to be either carpet, abrasive or vinyl. Available in recessed style for installation into surround frame, or surface mounted.
Finish
Tread Rails and recessed frame to be fabricated of 6063-T6 alloy in clear anodised finish. Optional finishes *(standard clear anodised)/(bright bronze gold anodised)/(bronze anodised). *Delete that which does not apply.
Surface Treads
Carpet
Tread rails shall be 100% nylon fibre face. Carpet unitary fusion bonded to guard against fraying, delamination or moisture penetration. Carpet to be positively locked into extruded aluminium tread rails. Colours to be selected from Latham Australia’s standard colour range.Abrasive
Tread Rails shall have continuous Latham Supagrit Slip Resistant Abrasive surface. Colours to be selected from Latham Australia’s standard colour range.Vinyl
Tread Rails shall have continuous Latham Ribbed Vinyl surface. Colours to be selected from Latham Australia’s standard colour range.
Mat Frames
Mat Frames must be level filled to mat depth with levelling compound or cement mix. Mat must be fully supported on a level surface. For correct installation mat frame should be delivered with mat.Furnish and install Entry Mat Frames to the following specification, as supplied by Latham Australia Pty Ltd, ph +612 9879 7888, fax +612 9879 7666. Entry Mat Frame type *(AAFaluminium standard)/(BAF - brass) size *(12 x 12 x 3mm standard)/(15 x 15 x 3mm)/(20 x 20 x 3mm)/(25 x 25 x 3mm)/(30 x 30 x 3mm)/(40 x 40 x 3mm)/(50 x 50 x 3mm)/(ACKD-10 aluminium cast-in place 45 x 90 x 12mm)/(BCKD-10 brass cast-in place 25 x 25 x 3mm) to suit.
*Delete that which does not apply.
Special Note
Consult with Latham Australia Engineering Division, where shaped recessed mats are required, and where recessed mats are to be installed in direct sunlight to allow for coefficient of linear expansion of metal components.Maintenance
Vacuum for dirt control. Wash carpet, abrasive and vinyl with Latham Gold-Chem Mat Wash 22XX.
Note: Mats must be rolled up before moving, they must not be dragged