premium architectural
stair & flooring products

Corner Guards

Interior Applications - Commercial & Industrial Use

CG Series Surface Mounted
The Latham CG-50 and CG-75 Surface Mounted Corner Guards offer the best protection for 90° external corners. The high impact textured cover snuggly fits over the continuous base section. The matching end caps mean the corner guards can be used in any lengths from project specific applications where very short corner guards are desired to full floor-to-ceiling corner guards.

The system should be considered for use in conjunction with HR and HBR Series Hand Rails, BR Series Bump Rails and WS Series Wall Sheeting. End caps are available with the system

PCGF-60 Flexible Corner Guard
The Latham PCGF-60 Flexible Adhesive Fixed Surface Mounted Corner Guards are specifically designed to accommodate varying wall/corner angles from flat to more than 135 degrees.


PCG-25 and PCG-50 Corner Guards
The Latham PCG-25 and PCG-50 Adhesive Fixed Surface Mounted Corner Guards offer protection for 90° external corners. The corner guards can be used in any lengths from project specific applications where very short corner guards are desired to full floor-to-ceiling corner guards. The PCG Corner Guards are fixed with Latham’s special field applied FT-13 high strength double-sided tape, or in some applications the PCG Corner Guards can be permanently fixed using Latham Thixotropic Epoxy Adhesive.

The system should be considered for use in conjunction with HR and HBR Series Hand Rails, BR Series Bump Rails and WS Series Wall Sheeting.

General Information
All Latham Corner Guards are supplied in 3625mm lengths for site cutting to the required dimensions. The quantity of End Caps required for the CG-50 and CG-75 profiles should be calculated and ordered with the Corner Guard section. It is common practice for floor-to-ceiling wall protection to be installed without end caps, whilst floor-to-specific-height and above-floor-to-specific-height are installed with 1 or 2 end caps..